How to Clean a Rug Properly
An area rug is often the piece that brings your room together, but as we all know, it often becomes dirty very quickly because everyone walks over it, food is spilt…not to mention any pets that you may have who rub themselves against it. Sometimes vacuuming is not enough to get the rug back to its original condition. Here are some tips to bring the rug back to its best, thanks to Rug Cleaning NYC.
Should You Clean It?
The last thing you want to do is to make the rug look worse than it already is. This is why we would recommend that if you have an antique carpet, or a Persian rug for example, that you should leave it to professional rug cleaners. These rugs are expensive, and you shouldn’t mess around with them unless you know exactly what you are doing.
Tools Needed
Here are the tools you will need to clean your rug.
- Specialist shampoo for rugs (or you could use a detergent)
- Bucket
- A brush with nice soft bristles. If you don’t have a brush like that, a sponge will often be an adequate replacement
- Clean Water
1) Remove Dirt and Any Noticeable Debris Visible on the Rug
First of all, make sure you take the time to vacuum on both sides of the rug before you start to clean it.
2) Setup Your Cleaning Solution
For those of you who have specialist rug shampoo, make sure you carefully follow the directions on the bottle, as different products have different preparation procedures. Make sure you do not use hot water. If you do, this can cause the rug to shrink, and in some cases, cause fading.
3) Check the Colors Don’t Run
Before you start vigorously scrubbing your rug, it is crucial that you make sure that the cleaner you are using doesn’t lead to the colors of the rug running. To guard against this, you can complete a test of the solution in a small corner of the rug. Or, check that your rug is “colorfast”.
4) Wash the Rug
Now you can proceed with washing the rug with your soft-bristle brush or sponge. It is important to try and work the solution into a nice lather to maximize the effectiveness of the cleaning. We would recommend letting the cleaning solution sit on the rug for a few minutes.
5) Rinse the Rug
Once you have finished your cleaning, you can then rinse the rug. We would recommend using buckets of clean water.
6) Remove Any Excess Water on the Rug Before Drying
Before you can let the rug dry, try and remove as much water as you can. This will allow the rug to dry faster. For drying the rug, make sure you lay the rug flat. If you have any fans, this will also speed up drying.
If you have a carpet that needs cleaning, we would recommend you check out Carpet Cleaning NYC, who offer a wide range of cleaning services.
The post How to Clean a Rug Properly appeared first on FeedsPortal.com.